engineering plastic

High-Density Polyethylene (HDPE) - a linear polymer, High-Density Polyethylene (HDPE) is prepared from ethylene by a catalytic process. The absence of branching results in a more closely packed structure with a higher density and somewhat higher chemical resistance than LDPE.

High molecular weight Polyethylene 500 also known as HMW-PE or PE 500 is thermoplastic with high molecular weight (as determined by viscometric method). Thanks to their high molecular weight, this type of HMW-PE is ideal material for applications requiring excellent sliding properties and wear resistance.

PE 1000 / PE-UHMW sheets - Antistatic ESD This Polyethylene UHMW material comes with permanent antistatic properties. The electrostatic surface charge is strongly reduced, and a as a result the dust is not attracted and no electrostatic discharge occurs.

PE 1000 / PE-UHMW sheets - Antistatic ESD This Polyethylene UHMW material comes with permanent antistatic properties. The electrostatic surface charge is strongly reduced, and a as a result the dust is not attracted and no electrostatic discharge occurs.

Torlon® 4301 is a wear-resistant grade of polyamide-imide (PAI) resin. It has a good balance of mechanical properties and wear resistance. It offers high flexural and compressive strength with a low coefficient of friction and outstanding wear resistance at both high velocity and high pressure conditions.

PEEK (Polyetheretherketone) – properties & applications

We process the high performance plastic PEEK (Polyetheretherketone) under the brand name SUSTAPEEK as semi-finished products in the form of sheets, round rods and tubes as well as machined components.

Polyamide 6 is the most common extruded polyamide and offers a balanced combination of all typical characteristics of this group of materials.

TECAPEEK  PEEK UNFILLED

Polyetheretherketone (PEEK) - TECAPEEK is a high performance, high temperature, semi crystalline thermoplastic manufactured by Ensinger and may use Victrex® PEEK 450G or Solvay‘s KetaSpire® KT-820 polymer.

Torlon® 4203 Sheets Rods.
Torlon polyamide-imide offers excellent compressive strength and the highest elongation of the Torlon® grades. It also provides electrical insulation and exceptional impact strength. This Torlon grade is commonly used for IC Test Sockets & Handlers, as well as, electrical connectors and insulators due to its high dielectric strength.

SUSTAMID 66 is an extruded general purpose nylon (Polyamide 66). Nylon is one of the original engineering plastics and is still today the material of choice for many bearing and wear applications.

POLYTETRAFLUOROETHYLENE (PTFE/TEFLON)
PTFE, also known as Teflon, is a non-toxic thermoplastic that is being used in many industries. PTFE has one of the lowest frictional coefficients of 0.10 as compared to any other plastic. PTFE also maintain high strength, toughness and flexibility at temperature below zero degree celcius.

Ketron® CA30 PEEK (30% Carbon Fiber-Reinforced) The addition of carbon fibers enhances the compressive strength and stiffness of PEEK, and dramatically lowers its expansion rate. It offers designers optimum wear resistance and load carrying capability in a PEEK-based product.